SATO DR300 Printer User Manual


 
DR300 Operator Manual
20
Close Cover.
Stop Position Adjustment
The correct stop position for dispense mode is the position where label is 2-3mm on
backing paper. Adjust OFFSET (VR) to obtain correct stop position.
There may be cases when the dispenser does not function properly due to the
thickness of the labels used.
Printing accuracy at peeling is V (Vertical) direction ± 1.5 mm, label size
direction ± 1.0mm.
Dispenser unit is effective for label pitch 25-181mm. However, label size
limitation may vary with application conditions.
Labels over 100mm may curl at dispense due to the nature of the material.
There is no remedy for this.
Chapter 4 - Setting of Label and Carbon Ribbon