Filter
Top Products
C3419M-D (11/08) 5
7. Install the back box by compressing the spring clips and pushing the back box through the hole. Tighten the screws
until you hear a clicking noise.
8. Connect the wiring to the circuit board inside the back box. When finished, close the door to the back box and turn on
the power. The green LED will glow.
NOTES:
• Aux 1: Maximum 2 A at low voltage (<40 V)
Aux 2: Maximum 30 mA at 32 VDC
• If you are using both unshielded twisted pair (UTP) wiring and a translator board, install the UTP wiring before
installing the translator board.
WARNING: An electrical short in the back box may occur if the metal BNC connector is not completely covered by
the protective boot.