Seagate 7200.3 Computer Drive User Manual


 
Momentus 7200.3 SATA Product Manual, Rev. C 21
3.4 Drive mounting
You can mount the drive using four screws in the side-mounting holes or four screws in the bottom-mounting
holes. See Figure 4 for drive mounting dimensions. Follow these important mounting precautions when mount-
ing the drive:
Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.
Use only M3 UNC mounting screws.
Do not overtighten the mounting screws (maximum torque: 4.0 inch-lb).
Four (4) threads (0.080 inches) minimum screw engagement recommended.
Measurements shown in Figure 4 are in inches.
Figure 4. Mounting dimensions—top, side and end view
+
Recommended
case temperature
measurement
location
Breather Hole
Do not cover
or seal.
3.95 +/- .010