Filter
Top Products
Cheetah 4LP Installation Guide, Rev. B 43
W/WD drives
W/WD drives sectionSetting the SCSI ID jumpers
Use the J6 jumper block to set the SCSI ID (Figure 11). To
change the SCSI ID, install jumpers on the appropriate pins as
shown in the illustration. Optional connections to switching cir-
cuits in host equipment are provided on J1 auxiliary to set the
SCSI ID (see Figure 12).
Figure 11. Setting the SCSI ID on model “W” and “WD”
drives
J6 [1]
Note:
[1] Do not remove
cover from pins
13 through 20
(darkened area).
SCSI ID = 0 (default)
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15
J6
J2
Pin 1
End
Jumper Plug
(enlarged to
show detail)
Pin 1