Filter
Top Products
SEAGATE ENTERPRISE CAPACITY 3.5 HDD V4 SAS PRODUCT MANUAL, REV. A 37
7.0 ABOUT FIPS
The Federal Information Processing Standard (FIPS) Publication 140-2 is a U.S. Government Computer Security Standard used to
accredit cryptographic modules. It is titled 'Security Requirements for Cryptographic Modules (FIPS PUB 140-2)' and is issued by the
National Institute of Standards and Technology (NIST).
Purpose
This standard specifies the security requirements that will be satisfied by a cryptographic module utilized within a security system protect-
ing sensitive but unclassified information. The standard provides four increasing, qualitative levels of security: Level 1, Level 2, Level 3 and
Level 4. These levels are intended to cover the wide range of potential applications and environments in which cryptographic modules may
be employed.
Validation Program
Products that claim conformance to this standard are validated by the Cryptographic Module Validation Program (CMVP) which is a joint
effort between National Institute of Standards and Technology (NIST) and the Communications Security Establishment (CSE) of the Gov-
ernment of Canada. Products validated as conforming to FIPS 140-2 are accepted by the Federal agencies of both countries for the pro-
tection of sensitive information (United States) or Designated Information (Canada).
In the CMVP, vendors of cryptographic modules use independent, accredited testing laboratories to have their modules tested. National
Voluntary Laboratory Accreditation Program (NVLAP) accredited laboratories perform cryptographic module compliance/conformance
testing.
Seagate Enterprise SED
The SEDs referenced in this Product Manual have been validated by CMVP and have been thoroughly tested by a NVLAP accredited lab
to satisfy FIPS 140-2 Level 2 requirements. In order to operate in FIPS Approved Mode of Operation, these SEDs require security initial-
ization. For more information, refer to 'Security Rules' section in the 'Security Policy' document uploaded on the NIST website. To refer-
ence the product certification visit -
http://csrc.nist.gov/groups/STM/cmvp/documents/140-1/1401vend.htm, and search for “Seagate”.
Security Level 2
Security Level 2 enhances the physical security mechanisms of a Security Level 1 cryptographic module by adding the
requirement for tamper-evidence, which includes the use of tamper-evident coatings or seals on removable covers of the
module. Tamper-evident coatings or seals are placed on a cryptographic module so that the coating or seal must be bro-
ken to attain physical access to the critical security parameters (CSP) within the module. Tamper-evident seals (example
shown in Figure 14, page 37) are placed on covers to protect against unauthorized physical access. In addition Security
Level 2 requires, at a minimum, role-based authentication in which a cryptographic module authenticates the authorization
of an operator to assume a specific role and perform a corresponding set of services.
Figure 14. Example of FIPS tamper evidence labels.
NOTE
Image is for reference only, may not represent actual drive.