Filter
Top Products
Elite 9 Installation Guide, Rev. B 27
Figure 9 illustrates a typical synchronized spindle
configuration.
After connecting each drive with spindle sync cables,
you must designate a master spindle sync reference
source. This master source is normally a disc drive
located on the same SCSI bus as the other drives you
want to synchronize with. To designate a drive as the
master, use SCSI interface commands. Refer to the
Product Manual
for information about using these
commands.
Figure 9. Spindle sync diagram
Master Sync
Source
Host
(or other drive)
Spindle
Control
Drive 1
+5V
R
T
J4A
24
23
Spindle
Control
Drive 2
+5V
R
T
J4A
24
23
Spindle
Control
Drive n
+5V
R
T
J4A
24
23
Sync Interface
System
Interface