Filter
Top Products
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential application. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Seiko Instruments could void the
user’s authority to operate the equipment.
Applicable EC Directives and Standards
Directive Title
89/336/EEC EC Electromagnetic Compatibility Directive
73/28/EEC EC Low Voltage Directive
2002/96/EC ECC Waste of Electronic Equipment (WEEE)
ECC Restricting the use of Certain Hazardous Substances in
Electrical and Electronic Equipment (RoHS)
Standards Title
EMC EN55022(1998) class B
EN55024(1998), EN61000-3-2(1995), EN61000-3-3(1995)
LVD EN60950/1992 +A1/1993, +A2/1993, +A3/1995, +A4/1997,
+A11/1997
Copyright
All rights reserved. No parts of this publication may be reproduced, stored in a
retrieval system, or transmitted, in any form, or by any means, electronic, mechanical,
photocopying, recording, or otherwise without the prior written permission of Seiko
Instruments USA Inc. No patent liability is assumed with respect to the use of information
contained herein. While every precaution has been taken in the preparation of this
publication, Seiko Instruments USA Inc. assumes no responsibility for errors or omissions. Nor
is any liability assumed for damages resulting from the use of information contained herein.
Further, this publication and features described herein are subject to change without
notice. Copyright © 1989-2006 by Seiko Instruments USA Inc. All rights reserved.
Trademark Information
IBM is a registered trademark of International Business Machines Corporation. Microsoft
and Windows are registered trademarks of Microsoft Corporation. SII and the SII logo are
registered trademarks of Seiko Instruments Inc. Smart Label Printer is a registered trademark
and SmartLabels, and Smart Label Icons are trademarks of Seiko Instruments USA Inc.
Other products mentioned in this guide are trademarks or registered trademarks of their
respective companies.
Seiko Instruments USA Inc., 2990 Lomita Blvd., Torrance, California 90505 USA