Sharp AR-M450 Printer User Manual


 
5-15
5
Troubleshooting (concerning the finisher)
Check the list below before contacting the SHARP Service Center.
FINISHER
Problem
Stapling position is
not correct.
The finisher does
not operate.
Stapling cannot be
performed.
Stapling position not set properly in the
stapling setting?
The finisher is open or the top cover, front
cover or paper guide of the finisher open?
Message indicating need to remove paper
from the stapler compiler displayed?
Message requesting check for the staple
unit displayed?
Message requesting adding staples
displayed?
Different size paper included?
Paper heavily curled?
Check the stapling position setting. (See page xx.)
Close all covers. (See pages xx and xx.)
Remove all paper from the stapler compiler following
the procedure described in step 1 on page xx.
Remove jammed staples. (See page xx.)
Replace the staple cartridge. (See page xx.)
Stapling cannot be performed onto different size
paper.
Paper may be curled heavily depending on the paper
type and quality. Remove paper from the paper tray
or the bypass tray, turn it upside down, and load it
again.
Solution