Filter
Top Products
AR-M350U UNPACKING AND INSTALLATION 6-1
[6] UNPACKING AND INSTALLATION
1. Installing procedure flowchart
There are many combinations between this machine and option units. For installing option units, observe the following procedures for efficiency.
To install the devices efficiently, follow the procedure below.
Some peripheral devices may have been installed as standard devices depending on the main unit model.
Part of descriptions and illustrations may be different.
* When installing an option, refer to the Service Manual for that option and or the AR-M350 / M450 Service Manual.
Scanner/document feeder device
Main unit
Main unit
Finishing device
Finishing device
Duplex/bypass device
Finishing device
Paper feeding deviceDuplex device
Paper feeding device
Scanner/document feeder device
Start of installation
End
AR-D13/AR-DC1
AR-D14/AR-DC1
Main unit
*
AR-EF1 /AR-RK1
AR-HD3
AR-FX5/AR-MM9
AR-PK1
AR-NS2
AR-NC5J
(Not required for the AR-M350N/M450N)
AR-P14
(Only AR-M350U/M450U)
Extended memory
AR-D13/AR-D14/
AR-DU3/AR-DU4
AR-DU3
AR-DU4
AR-MS1/AR-DC1
AR-FN6 /AR-DC1
AR-FN7
AR-PN1A / B / C / D
No
Yes
Duplex/bypass
device installed?
No
No
No
Finishing device
installed?
Scanner/document
feeder installed?
Yes
Yes
Yes
Controller board,
facsimile unit or other
electric devices
installed?
When installing a paper feeding device, an optional power supply unit or a duplex/bypass device, be
sure to re-attach the rear cabinet, the AC inlet cover, and the harness cover of the main unit at the
end of installation as needed.
When installing a controller board, a facsimile unit, and other electric devices, be sure to install them
one at a time.
Only off center adjustment is needed for AR-DU3.
Install controller board,
facsimile unit or other electric
devices.
2)
Paper guide position adjustment/off center adjustment
1) Installation of driver software, setting,
and operation check
Main unit/AR-EF1/AR-NC5J/AR-HD3/
AR-FX5/AR-PK1/AR-NS2/AR-P14
[Electrical setting/adjustment]
Main unit, paper feeding
device, and power supply
unit.
Install duplex/pypass device.
Install finishing device.
Install scanner/document feeder.