Sharp DM-4500 Printer User Manual


 
6-13
6
KEY OPERATOR PROGRAMS
System settings (network settings)
These programs are set when this product is used
as a network printer.
In Network Settings, the following programs can
be set. After each program is set, exit the key
operator program, turn off the main switch, and then
turn on the main switch again after a while. The
program that has been set will be effective at this
time.
IP address setting
Enable TCP/IP
Enable NetWare
Enable EtherTalk
Enable NetBEUI
Reset the NIC
NOTE
For setting and modification of "Network settings", be sure
to consult with the network administrator.
IP address setting
When using this product in a network that uses the
TCP/IP protocol, use this program to set the IP
address (IP address, IP subnet mask, and IP
gateway) of this product. When using this product in
a network that uses the TCP/IP protocol, set also
the program "Enable TCP/IP" below.
Enable TCP/IP
When using this product in a network that uses the
TCP/IP protocol, set this program. Also set the IP
address using the program "IP address setting"
above.
Enable NetWare
When using this product in a network that uses the
NetWare protocol, set this program.
Enable EtherTalk
When using this product in a network that uses the
EtherTalk protocol, set this program.
Enable NetBEUI
When using this product in a network that uses the
NetBEUI protocol, set this program.
*
1
Reset the NIC
This program is used to reset all setting items of
NIC (Network Interface Card, namely Print Server
Card) of this product to the factory default settings.
NOTE
For programs marked with *1, a confirmation message for
execution will appear at the end of the programs.
When the operation panel on the main unit is used,
execution of the program can be canceled by pressing
the [BACK/C] key.
When the operation panel with touch panel is used,
execution of the program can be canceled by touching
the [CANCEL] or [NO] key.