Filter
Top Products
1-9
1
B/W scanner module/DSPF
This unit is a monochrome scanner that allows
automatic feeding of sheet originals and continuous
scanning. The B/W scanner module/DSPF (Dual
Single Pass Feeder) can scan two-sided sheet
originals and can scan both sides at a time. Also a
flat bed type document glass is provided in this unit
for scanning an original that cannot be fed such as a
book and thick original.
Upper exit tray extension
Mount this unit to the upper paper exit tray. This unit
is needed for output of 11" x 17" (A3) paper.
Finisher
Sorted output sheets or grouped output sheets by
page are offset stacked so that each set can be
taken out easily.
Also sorted output sheets can be stapled.
Mail-bin stacker
This unit is an output sheet sorting unit that contains
seven bins. When printed sheets are output in the
printer mode, a bin to which printed sheets are to be
deposited can be specified in the printer driver. The
bins can be classified by persons or by sections
depending on users so that the users deliver their
printed sheets to their specified bin. Sorted output
separated from the other users, therefore, can be
performed.
Output sheets in the copy and fax modes are
deposited in the top tray other than these seven bins.
Stand/MPD & 2000 sheet paper drawer
This is a paper feed unit that contains two paper
trays. The upper tray is equivalent to the multi purpose
drawer. The lower tray holds approximately 2000
sheets of 20 lbs. (80 g/m
2
) paper.
Multi purpose drawer
Holds paper. Up to 500 sheets of 20 lbs. (80 g/m
2
)
paper can be loaded. Also special papers such as
envelopes (standard sizes only) and Japanese
postcard can be set.
Stand/3 x 500 sheet paper drawer
This is a paper feed unit that contains three paper
trays. The upper tray is equivalent to the multi purpose
drawer. Each of the lower two trays holds up to 500
sheets of 20 lbs. (80 g/m
2
) paper.
Saddle stitch finisher
Sorted output sheets or grouped output sheets by
page are offset stacked so that each set can be
taken out easily. Also sorted output sheets can be
stapled at the edge or at the center for center-stapled
binding.
In addition, if a punch module is installed as a
peripheral unit, punch holes can be made in the
output sheets for filing.
Duplex module
Unit for automatic two-sided printing.
Duplex module/bypass tray
This module is equipped with a unit for automatic
two-sided printing and a bypass tray manual paper
feeding.
Exit tray
Mounted to the paper output port of a duplex module
or a duplex module/bypass tray.
PART NAMES AND FUNCTIONS
For installation of a peripheral unit, installation of some other peripheral units may be needed together and installation
of some peripheral units may not be possible together. See page xx, “COMBINATION OF PERIPHERAL UNITS.”
Peripheral units are basically optional but some units may be provided as standard units depending on the main unit
model.