Filter
Top Products
Basic
Operation
29
On-screen Display (confirmation message)
1
2
Turning the Power off (Putting
the Projector into Standby Mode)
Press SSTANDBY/ON on the pro-
jector or eSTANDBY on the re-
mote control, then press that but-
ton again while the confirmation
message is displayed, to put the
projector into standby mode.
Unplug the power cord from the AC
outlet after the cooling fan stops.
• The power indicator on the projector
blinks in green while cooling.
• The power indicator changes to red when
the projector finishes cooling.
• Do not unplug the power cord during projection
or cooling fan operation. This can cause dam-
age due to rise in internal temperature, as the
cooling fan also stops.
Info
R
STANDBY
button
Locking the Operation Buttons
on the Projector (Keylock
Function)
a Taking the Keylock off
Hold down T ENTER on the projector for
about 5 seconds.
a Locking the Operation Buttons
Hold down T ENTER on the projector for
about 5 seconds while the projector is being
turned on.
• The keylock function does not affect the op-
eration with the remote control buttons.
• You cannot use the keylock function while the
projector is warming up.
• When the projector is in standby mode, you
can release the keylock by holding down
T ENTER and S STANDBY/ON on the pro-
jector simultaneously for about 5 seconds.
• Keylock does not function while the projector
is: displaying “Menu” screens, in standby
mode, warming up, changing input signals,
operating “Auto Sync” function, or in “Freeze”
mode.
Info
ROn-screen Display
ROn-screen Display
Use this function to lock the operation buttons
on the projector.
DT-100_EN_g 05.7.22, 5:52 AM29