Filter
Top Products
Sending a Fax by Automatic Dialing
55
2. Sending
Documents
Automatic redialing
If you use automatic dialing (including Direct Keypad Dialing) and
the line is busy, the fax machine will automatically redial the number.
The fax machine was set at the factory to make 2 redialing attempts at
intervals of 5 minutes.
To stop automatic redialing, press the
CHANGEOVER
key to show
the telephone line status in the display (make sure that RECALL
MODE appears on the top line of the display and the number of the
receiving party appears on the bottom line to the right), and then press
the
STOP
key.
If desired, you can change the number of redial attempts with Option
Setting 6, and the interval at which redialing takes place with Option
Setting 7. See Chapter 5,
Optional Settings
.
Memory Retransmission
If a line error or power failure occurs during any type of memory
transmission, your fax will automatically redial the number and
attempt to complete the transmission. Retransmission will begin from
the page which was being transmitted when the error occurred.
The fax machine has been set at the factory to make 10 attempts at
retransmission, with each attempt made immediately after the
previous attempt. If desired, you can change the number of attempts
by changing Option Setting 17, and have the fax wait a selected
number of minutes between each attempt by changing Option Setting
18. See Chapter 5,
Optional Settings
.
♦ To stop retransmission, press the
CHANGEOVER
key to show the
telephone line status in the display (make sure that RETRY MODE
appears on the top line of the display and the number of the receiv-
ing party appears on the bottom line to the right), and then press the
STOP
key.
♦ The numbering of pages retransmitted will begin from "1" again.
all-FO4700.book Page 55 Friday, June 11, 1999 1:57 PM