Filter
Top Products
27
This chapter explains what to do when a paper misfeed occurs in the machine.
Removing misfeeds
When a paper misfeed occurs, "A misfeed has occurred." appears in the touch panel and printing stops. In this event,
touch the [Information] key in the touch panel. When the key is touched, instructions for removing the misfeed will
appear. Follow the instructions. (The approximate locations of possible misfeeds are indicated by blinking marks as
shown below.)
Paper misfeed illustrations
If you require more information when reading the instructions in the touch panel, see the paper misfeed illustrations on
the following pages. Refer to the illustration below and then go to the appropriate illustration (1 to 14) for your situation.
☞ (1)-(2): page 28, (3)-(5): page 29, (6)-(10): page 30, (11)-(14): page 31
REMOVING MISFEEDS
Caution
The fusing unit is hot. Take care not to burn yourself when removing a misfeed.
• When removing misfed paper, do not touch or damage the transfer belt.
• Carefully pull the paper out without tearing it.
• A misfeed may have occurred inside the machine. Check carefully and remove the
misfeed.
• If the paper tears, be sure to remove all pieces from the machine.
A misfeed has occurred.
Turning M/C off now causes data loss.
Information
OK
Misfeed location
Transfer belt
Fusing unit
(1)
(11) (12)
(2)
(10)
(8)
(13)
(14)
(9)
(3) (4) (5) (6)
(7)