Filter
Top Products
-58
Translucent screen
Audience
When the image is projected from
behind the screen using the default
setting.
▼On-screen Display
Projecting a Reversed Image
Projection from behind the Screen
■ Place a translucent screen between the projector and the
audience.
■ Reverse the image by setting “Rear” in the “PRJ Mode” menu.
(See page 49.)
Projection Using a Mirror
■ Place a mirror (normal flat type) in front of the lens.
■ When the translucent screen is placed on between the mir-
ror and audience, set to “Front” in the “PRJ Mode” menu.
(See page 49.)
■ When the mirror is placed on the audience side, set to “Rear”
in the “PRJ Mode” menu. (See page 49.)
Info
•When using a mirror, be sure to carefully position both the
projector and the mirror so the light does not shine into the
eyes of the audience.
Ceiling-mount Setup
■ It is recommended that you use the optional Sharp ceiling-
mount bracket for this installation.
Before mounting the projector, contact your nearest Sharp
Authorized Projector Dealer or Service Center to obtain the
recommended ceiling-mount bracket (sold separately).
• AN-B10T ceiling-mount bracket, its AN-TK201 and
AN-TK202 extension tubes (for countries other than the
U.S.A.).
■ Be sure to adjust the position of the projector to match the
distance (H) from the lens center position (see page 57) to
the lower edge of the image, when mounting the projector on
the ceiling.
■ Do not mount the projector upside down.
The image is reversed.
Set to “Front”
Audience
Translucent screen
Mirror
Set to “Rear”
Audience
Mirror
Setting up the Screen
Set to “Rear”.
▼On-screen Display