Sharp XE-A217B Cash Register User Manual


  Open as PDF
of 136
 
120
SettingthedateandtimewhentheautomaticEUROmodicationoperationshouldbeexecuted
Tocertainlyexecutetheautomaticmodicationoperation,youcanprogramthescheduleddateandtimeto
executetheautomaticEUROmodicationoperation.Fromtendaysbeforethepresetdate,theremaining
days are printed at the bottom of the daily full resetting report.
Dateandtimesettingwillberesetaftertheexecutionofautomaticmodicationoperation,andagainyou
canprogramthedateandtimeforthenextautomaticmodicationoperation.
AlsoyoucanmaketheautomaticEUROmodicationoperationcompulsory.Whentheabove-mentioned
preset date and time has come, and also when you start an entry in the REG/MGR mode, the error message
“EURO CHANGE ENTRY COMPULSORY” will be displayed. You cannot start any operation in the REG/
MGR mode until you make the operation.
AutomaticEUROmodicationoperation
1. Select “5 X2/Z2 MODE”.
2. Select “3 EURO STATUS” from the menu.
3. Select the status you want to set (B, C or D) referring to the table on the previous page. Press the
P
key to toggle the options.
Please note that once you set a status, you cannot return to the previous status(es).
Important note
As for the miscellaneous keys, such as
J
and
¡
keys, and for the HALO setting, the automatic
conversion will not be made. You need to change the % rates or amounts in the PGM mode after the
executionoftheautomaticmodicationoperationforEUROsothattheyarebasedonamountsin
EURO.
NOTE
It is executed some of following operation which is needed for each status.
1) Issue General Z1 report. 2) Issue General Z2 report. 3) Clear GT1/2/3 and Training GT. 4)
Convert the unit price of DEPT/PLU from LOCAL currency to EURO. If new unit price is over the
max digits, its price is set as "0.00". 5) Change PGM function “EX1 AMOUNT PRINTING FOR
TOTAL AND CHANGE YES/NO”. 6) Change PGM function “EX1 CALCULATTION METHOD
DIVISION/MULTIPLICATION”. 7) Set “EX1 currency symbol” as the suitable data. 8) Set “EX1
TAB” as the suitable data. 9) Set “Domestic currency symbol” as EURO SYMBOL. 10) Set
“Domestic TAB” as “2”. 11) Set “Rounding SYSTEM (Denmark/Sweden/Normal)” as “Normal”.
12) Set “Rounding up/down of the unit digits of AMOUNT” as “No”. 13) Set “Lowest digit entering
limitation of item” as “Arbitrary”. 14) Set “Lowest digit entering limitation of payment” as “Arbitrary”.
15) Set “Difference memory” as “No”. 16) Set “Rounding of foreign currency for EX” as “Round
off(4-DOWN,5-UP)”. (EURO Regulation)
NOTE
This job cannot set the following additional EURO function. You must set the following items by
eachprogrammingafterexecutingtheautomaticEUROmodicationoperation.
1) Exchange1 rate, (2) “Check, Credit operation for Exchange1 — YES/NO”
 previous next