Filter
Top Products
74
4
Remove the lamp unit.
Loosen the securing screws from the lamp
unit. Hold the lamp unit by the handle and
pull it in the direction of the arrow. At this
time, keep the lamp unit horizontal and do
not tilt it.
5
Insert the new lamp unit.
Press the lamp unit fi rmly into the lamp unit
compartment. Fasten the securing screw.
6
Replace the lamp unit cover.
Align the tab on the lamp unit cover (1)
and close it (2). Be careful not to get the
strap caught in the cover. Then tighten the
user service screw (3) to secure the lamp
unit cover.
Info
If the lamp unit and lamp unit cover
are not correctly installed, the power
will not turn on, even if the power
cord is connected to the projector.
•
Resetting the Lamp Timer
Reset the lamp timer after replacing the lamp.
Info
Make sure to reset the lamp timer only when
replacing the lamp. If you reset the lamp timer
and continue to use the same lamp, this may
cause the lamp to become damaged or
explode.
•
1
Connect the power cord.
Plug the power cord into the AC socket of
the projector.
2
Reset the lamp timer.
While simultaneously holding down
MENU, ENTER and
R on the projector,
press STANDBY/ON on the projector and
keep all four buttons pressed down until
the lamp indicator starts blinking green.
“LAMP 0000H” is displayed, indicating
that the lamp timer is reset.
•
•
•
•
•
•
4
Handle
Securing screws
Handle
Securing screws
5
6
AC socketAC socket
1
ENTER button
MENU button
R button
STANDBY/ON button
ENTER button
MENU button
R button
STANDBY/ON button
2
Regarding the Lamp (Continued)