Filter
Top Products
17
Quick Start
4. Adjust the projected image with the Setup Guide
_PP. 26, 27
1 After the projector turns on, the Setup Guide appears.
(When “Setup Guide” is set to “On”. See page 44.)
2 Follow the steps in the Setup Guide and adjust the focus, picture size, and height (angle).
3 After adjusting the focus, height (angle) and picture size, press ENTER to finish the Setup
Guide.
Correcting trapezoidal distortion using Keystone Correction.
5. Correct trapezoidal distortion
8. Turn the power off
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press the
button again while the confirmation message is displayed to put the projector into standby mode.
On-screen display
On the
projector
On the remote
control
_P. 25
On the projector
On the remote control
Shrinks
upper side.
Shrinks
lower side.
_P. 28
Select the “COMPUTER” using INPUT on the projector or COMPUTER on the remote control.
6. Select the INPUT mode
• When you press INPUT on the projector, the INPUT list appears.
Press '/" to switch the INPUT mode.
On the
projector
On the remote
control
INPUT list
_P. 29
On-screen display (RGB)
RGB
1024 × 768
COMPUTER
7. Turn the computer on
INPUT
COMPUTER
DVI-D Computer
*
*
XR-32X only
D
DVI-D Video
D