Filter
Top Products
11
3: Installation Procedures
• Overview
• Part 1: AirCard 580 software installation
• Part 2: Inserting and removing the AirCard 580 and driver installation
• Part 3: Activating the AirCard 580 with a service provider
Overview
This chapter is separated into three parts that guide you through the steps necessary to install and to
begin using the AirCard 580.
Note: Do not insert the AirCard 580 into your PC Card slot before installing the software.
The basic steps are:
1. Insert the AirCard 580 installation CD into your CD-ROMdrive to install Watcher.
2. Insert the AirCard 580 into the PC Card slot to install theAirCard 580 driver.
3. If the AirCard 580 has not been pre-activated, use the Activation Wizard to configure the AirCard
580 (as described in Part 3 of this chapter: “Activating the AirCard 580 with a service provider,”
beginning on page 14).
Before you begin the installation process, ensure your PC meets the hardware requirements described
below.
System requirements
The AirCard 580 wireless modem is supported on notebook PCs equipped with the following Windows®
operating systems:
• Windows 98 SE
• Windows Me
• Windows 2000 (with Service Pack 3 for optimal performance)
• Windows XP
Note: The AirCard 580 is not designed to function in Handhelds and Pocket PCs, nor does it support SMS or voice
services.
To install the AirCard 580, you require these system resources
Table 3-1: System Resource Requirements
Card Slots 1 Type II PCMCIA (PC Card) Slot
Disk Drive CD-ROM (for installation only)
Processor Pentium 150 MHz or higher
Memory at least 32 MB
Disk Space at least 14 MB
Dial-up Networking DUN bound to TCP/IP
3