Filter
Top Products
24
Table 4-3: Settings Menu - General Tab Options Option Choices Description
Option Choices Description
Start in System Tray
Mode
On
Off (default to Full
Mode at launch)
When this option is enabled, Watcher will launch from the
system tray. (See System Tray Mode on page 26).This
feature is turned off by default (it is unchecked) and
Watcher launches in Full Mode.
Run AirCard 580
Watcher at Startup
On (default)
Off
When this option is enabled, Watcher automatically
launches when your notebook PC is powered on. Turning
this feature “off” disables auto launch and Watcher may
only be opened through the desktop shortcut or from the
start menu (See page 17 in this
chapter “Launching Watcher”).
Enable Auto-Connect On
Off (Default)
When this option is enabled, Watcher automatically
establishes a connection at startup, and reestablishes a
connection if the connection is dropped. If you prefer to
manually establish a connection, turn the feature off
(default).
Cal l Lost Alert On (default)
Off
When enabled, a pop-up window and warning sound notify
you when a connection is dropped.
Card Eject Warning On (default)
Off
When enabled, a message regarding proper card removal is
displayed when you exit Watcher.
Premium Service
Alert
On (default)
Off
When enabled, a notification appears each time an a
connection attempt the high-speed 3G CDMA 1xEVDO
BroadbandAccess network is made.
Tray Mode Alert On (default)
Off
When enabled, you are prompted to indicate whether you
want to close Watcher or minimize Watcher when you
select the system tray shortcut action button.
The System Select menu displays the current selection
when the Settings tool is launched while the modem is
connected and powered on. If the modem is not connected
or powered on, the menu will be grayed out. These settings
cannot be changed during an active data call.
Note: Do not change the default System Select
option, unless instructed to do so by a CLARO
Customer Service Representative
System Select Automatic
Automatic A
Automatic B
Home Only
For security purposes, you have the option to lock the
AirCard 580 when not in use. Place a checkmark in the
check box entitled, “Lock Card” to enable this feature. By
enabling this feature, the AirCard 580 locks, disabling any
connection attempts, even if Watcher is set to "Auto
Connect". Each time you use the AirCard 580, you are asked
to enter a four-digit passcode. The default lock code is the
last four digits of your Directory Number. To change your
code, select “Change Lock Code” and follow the on-screen
instructions.
Tip: Access the About tab to locate your Directory
Number or contact CLARO Customer
Service.
Security Lock On
Off (default)