Support User Manuals

Sierra Wireless EV-DO Network Router User Manual

Open as PDF

of 182

Hardware Installation of the PinPoint-E

Rev 3.0B Feb.08 36

• Link‐Indicatesasuccessfulconnectiontothecellular

network.

• Reg(registration)‐IndicatesthePinPoint‐Ehasacquired

anIPfromVerizon.

• RSSI(signallevel)‐Lightshowsthestrengthofthesignal

andmaybe nearlysolid(strongsignal)orflashing(weaker

signal).Aslowflashindicatesaveryweaksignal.

• Tx(transmit)andRx(receive)‐Lightswillflashasdatais

transferredtoandfromtheRaven‐Emodemontheremote

network.

• Srvc(service)‐IndicateswhentheconnectionisEV‐DO.

Unlitindicates1x.

• GPS‐IndicatesaGPSfix.Whenlit,thePinPoint‐Ehas

GPScoordinatestoreport.

• On(power)‐Indicatesthepoweradapterisconnectedand

thereispowergettingtothePinPoint‐E.

• TheResetbuttonperformsthesamefunctionas

unpluggingpowerfromthemodemandpluggingitback

in.Resetwillnotalteranysavedconfigurationsettings.

Light Patterns

TheLEDsonthefrontofthemodemwillrespondindifferent

patternstoindicatemodemstates.

• Normal‐EachLED,mentionedabove,litasapplicable.

• Startup‐TheLEDswillcyclefromlefttoright.

• PassThrumode‐TheChan,Reg,andLinkLEDswillblink

intandem.TheTxandRxLEDswillblinkwhentrans

‐

mittingorreceivingdata.

• LowPower‐AllLEDswillbeoffexceptthepowerLED

whichwillblinkevery3seconds.

OTASP:Oneatatime,theNetwork,SignalandAcitivityLED

willflash(respectively).

RSSI LED Ranges

RSSI/Signal LED Status Ranges of RSSI (dBm)

On Solid Equal to or stronger than -69

Fast Blink -70 to -79

Normal blink -80 to -89

Slow Blink -90 to -99

Extinguished Equal to or weaker than -100

previous next