Support User Manuals

Sierra Wireless EV-DO Network Router User Manual

Open as PDF

of 182

Global Positioning System (GPS)

Rev 3.0B Feb.08 90

RAP Reports Over-The-Air (Remote)

ToconfigureyourPinPoint‐EtosendRAPreportstoaremote

AVLhostserver,youwillneedtoset3commands:*PPIP,

*PPPORT,and*PPGPSR.

a. SettheIPaddressofthehostwith*PPIPanddesired

portonthehostwith*PPPORT.

Figure 9-14: AceManager : PinPoint - *PPIP, *PPPORT

b. SettheGPSReportType,using*PPGPSR,toyour

preferredRAPreporttype.

11‐GPS‐GlobalPositioningSystemdata

12‐GPS+Date‐GPSdatawiththeUTCtimeand

date

13‐GPS+Date+RF‐GPSdatawiththeUTCtime

anddateandRadioFrequencyinformation fromthe

antenna.

Figure 9-15: AceManager : PinPoint - *PPGPSR

Tip: If your AVL host server uses a dynamic IP address or needs to

change its IP address for any reason, you can use the RAP configu-

ration command to change the value for *PPIP.

RAP Reports over a Local Connection

LocalreportsaresenttothelocalIPaddressofthecomputeror

deviceconnecteddirectlytoaportonthePinPoint‐E.The

reportsaresentusingPPPorSLIPforserial.Toconfigurethe

modemtosendreportstothelocalIPaddress,youwillneedto

set3

commands:S53intheMiscgroupand*PPLATSand

*PPLATSRinthePinPointgroup.

a. SettheS53porttothelocalporttowhichyouwantthe

reportssent.ThelocalIPaddresswillautomaticallybe

used.

previous next