Filter
Top Products
5
3. Click Start, then Run. Type in X:\setup.exe and
click OK. (Change X: to match your CD-ROM drive
letter)
4. Click Next, Next, at the Warning box click OK, then
click Finish to restart.
5. When the VIA ...Universal Host Controller is
detected, click Next.
6. Choose Search for the best driver... and click Next.
7. Clear all check boxes, click Next, Next, Next.
NOTE: If prompted for Windows 98SE Installation
CD, click OK. Insert this CD and click OK.
8. Click Finish.
9. When the VIA ...Universal Host Controller is
detected, click Next.
10. Repeat steps 6, 7 and 8.
11. When the USB Enhanced Host Controller is detected,
click Next.
12. Repeat step 6.
13. Clear all check boxes, click Next, Next, then Finish.
14. When the VIA OHCI IEEE 1394 Host Controller is
detected, click Next.
15. Repeat steps 6 and 13 to complete the installation.
Windows ME
1. Install the board, boot up the system, and insert the
driver CD.
2. When Windows boots up, at the Add New Hardware
Wizard window, click Cancel. Click No to decline
restart.