Filter
Top Products
6
3. Click Start, then Run. Type X:\setup.exe and click
OK. (Change X: to match your CD-ROM drive
letter).
4. Follow the on-screen instructions to install the
driver. When prompted click Finish to restart.
5. At the Add New Hardware Wizard, choose
Automatic search for a better ..., click Next, then
click Finish.
6. Click Yes to restart Windows to complete.
Windows 2000
Windows 2000 Service Pack 3 (SP 3) or later is required
for this installation.
If you have have Windows 2000 Service Pack 4 (SP4) or
later installed, Windows will automatically detect and
install the correct driver for this board. Otherwise, follow
all steps below.
1. Install the board, boot up the system, and insert the
driver CD.
2. When Windows boots up, at the Found New
Hardware Wizard window, click Cancel.
3. Click Start, then Run. Type X:\setup.exe and click
OK. (Change X: to match your CD-ROM drive
letter).
4. Click Next, Next to accept the license agreement,
then Next to install the USB 2.0 driver.
5. Click Yes to confirm restarting the system
automatically.
6. Click Yes to accept Software License Agreement,
then click OK.
7. Click the Print to File icon, then click OK.