Filter
Top Products
8
4. At the Windows 2000 Setup screen, press F6 to
install the RAID driver.
5. When prompted, press S to specify the location of
the driver.
6. Insert the floppy disk, then press Enter.
7. Select Initio INIC162x S-ATA RAID Driver For
Windows 2000, then press Enter.
8. Press Enter again continue and follow the on-screen
instructions to complete the Windows installation.
Do not remove the floppy disk until instructed.
When Windows installation completes, go to Initio SATA
RAID Manager GUI on page 13 and install the RAID
utility.
For An Existing Installation
1. Setup the RAID array prior to driver installation and
boot up to Windows.
2. At Found New Hardware Wizard, click Next.
3. Select Search for a suitable driver for my device
(recommended), then click Next.
4. Insert the driver CD, check CD-ROM drives, uncheck
the other boxes, click Next, then click Next again.
5. If the Digital Signature Not Found message appears,
click Yes. Our driver has been thoroughly tested for
stability and compatibility.
6. Click Next, then Finish.
7. Repeat step 5.
8. Restart Windows to complete the installation.
When Windows resumes, go to Initio SATA RAID
Manager GUI on page 13 and install the RAID utility.