Filter
Top Products
9
Windows XP/Server 2003
For A New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents
of the Floppy folder, found on the driver CD, onto a blank
floppy disk then follow the directions below.
1. Setup the RAID array prior to Windows installation.
2. Follow Microsoft Windows installation procedure.
3. Restart the computer if prompted by Windows'
installation. Otherwise, go directly to step 4.
4. At the Windows Setup screen, press F6 to install the
RAID driver.
5. When prompted, press S to specify the location of
the driver.
6. Insert the floppy disk, then press Enter.
For 32-bit Windows: Select Initio INIC162x S-ATA
RAID Driver For Windows XP/Server 2003, then
press Enter.
For 64-bit Windows: Select Initio INIC162x S-ATA
RAID Driver For Windows XP/Server 2003 AMD64,
then press Enter.
7. Press Enter to continue the installation, then follow
the on-screen instructions to complete the Windows
installation. Do not remove the floppy disk until
instructed.
When Windows resumes, go to Initio SATA RAID
Manager GUI on page 13 and install the RAID utility.
For An Existing Installation
1. Setup the RAID array prior to driver installation and
boot up to Windows.