Filter
Top Products
S
PANNING
T
REE
C
OMMANDS
4-183
adjusting the type of protocol messages the RSTP node transmits, as
described below:
- STP Mode – If the switch receives an 802.1D BPDU after a port’s
migration delay timer expires, the switch assumes that it is
connected to an 802.1D bridge and starts using only 802.1D
BPDUs.
- RSTP Mode – If RSTP is using 802.1D BPDUs on a port and
receives an RSTP BPDU after the migration delay expires, RSTP
restarts the migration delay timer and begins using RSTP BPDUs
on that port.
Example
The following example configures the switch to use Rapid Spanning Tree.
spanning-tree forward-time
This command configures the spanning tree bridge forward time globally
for this switch. Use the no form to restore the default.
Syntax
spanning-tree forward-time seconds
no spanning-tree forward-time
seconds - Time in seconds. (Range: 4 - 30 seconds)
The minimum value is the higher of 4 or [(max-age / 2) +1].
Default Setting
15 seconds
Command Mode
Global Configuration
Console(config)#spanning-tree mode rstp
Console(config)#