Filter
Top Products
C
ONFIGURING
THE
S
WITCH
3-26
If you download to a new destination file, go to the System, File
Management, Set Start-Up menu, mark the operation code file used at
startup, and click Apply. To start the new firmware, reboot the system via
the System/Reset menu.
Figure 3-10. Setting the Startup Code
To delete a file select System, File Management, Delete. Select the file
name from the given list by checking the tick box and click Apply. Note
that the file currently designated as the startup code cannot be deleted.
Figure 3-11. Deleting Files
CLI – Enter the IP address of the TFTP server, select “config” or
“opcode” file type, then enter the source and destination file names, set the
new file to start up the system, and then restart the switch.
.
Console#copy tftp file 4-84
TFTP server ip address: 10.1.0.19
Choose file type:
1. config: 2. opcode: <1-2>: 2
Source file name: v1000-18.bix
Destination file name: V1.0
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#config
Console(config)#boot system opcode:V1.0 4-90
Console(config)#exit
Console#reload 4-30