Filter
Top Products
83
Wireless Internet Camera must be set from a workstation on the
same subnet.
A3: Other possible problems might be due to the network cable.
Try replacing your network cable. Test the network interface of
the product by connecting a local computer to the unit, utilizing a
standard Crossover (hub to hub) Cable. If the problem is not
solved the Wireless Internet Camera might be faulty.
Q: Why does the Power LED not light up constantly?
A: The power supply used might be at fault. Confirm that you
are using the provided power supply DC 5V for the Wireless
Internet Camera and verify that the power supply is well
connected.
Q: Why does the Link LED not light up properly?
A1: There might be a problem with the network cable. To
confirm that the cables are working, PING the address of a know
device on the network. If the cabling is OK and your network is
reachable, you should receive a reply similar to the following
(…bytes = 32 time = 2 ms).
A2: The network device utilized by the Wireless Internet Camera
is not functioning properly such as hubs or switches. Confirm the
power for the devices are well connected and functioning.
A3: The wireless connection might be at fault. In ad-hoc mode
make sure the Wireless Internet Camera wireless channel and
SSID is set to match the PC/Notebook wireless channel and SSID
for direct communication.
Under infrastructure mode make sure the SSID on the
PC/Notebook and the Wireless Internet Camera must match with
the access point’s SSID.