Filter
Top Products
8
Part Location and Function
Chapter 1 Introduction
BW-RS101 Rear Panel
A Function switches
Use these switches to set the SCSI ID and unit functions. See “BW-RS101
Function Settings” on page 15 for details
B SCSI connectors
Connect SCSI cables (sold separately) to these connectors to link the host
computer and/or other SCSI devices.
C Air duct
Air is sucked through the duct for cooling the unit.
Note
Make sure that you do not block the air duct or impede the air flow.
D F.GND (ground terminal)
Connect the ground terminals of other devices to the unit's frame ground.
E AC IN connector
Connect the supplied AC power cord to this connector.
F Power switch
Pressing the “ ? ” side turns on the power. To turn off the power, press the “a”
side.
123456