Filter
Top Products
Supplement 1 - Capturing Video
If you have a VCR or camcoder connected via i.LINK (IEEE 1394), you can use
video recorded on a tape as video material. The following procedure captures
audio/video signal and creates an AVI file, so you can convert it into NSP format
using the same procedure shown in “Preparing Video Material” (page 7).
Note: These operations are not necessary to create the demonstration content
shown at the beginning.
Please contact your supplier or Sony sales representative for information on the
video devices that you can use for capturing.
Other video devices may be used, but depending on the device, some
operations, such as shuttle control and cue-up operations, may not be available.
1 Connect the VCR and PC using an i.LINK cable,
power the VCR on, and insert the desired cassette.
Close all windows except for the main menu.
2 Click [Capture] on the main menu.
3 Click [Folder], then select the folder in
which the AVI files should be stored.
4 Cue up the desired In point using the
buttons of the VCR control section, then
click [In].
The time code of the point appears.
6 Click [REC].
Capturing starts. It automatically ends at the
specified Out point.
5 Cue up the desired Out point, then click [Out].
The time code of the point and the duration of the clip appear.
You can check the video here.
VCR control section
[Live REC] is for live recording.
Clicking this button immediately starts capturing.
It stops when you click [Stop].
Captured AVI files are
shown here in the
Convert Material
window.
Click [Browse], then
select the folder
specified in step 3, if
necessary
Upon Conversion
14