Filter
Top Products
18
Projecting an Image
1 Press the ?/1 key on the main unit or
the 1 key on the Remote Commander.
The message appears if you press the ?/
1
key on the main unit. Press it again
according to the message.
The fan continues to run for a while to
reduce internal heat.
2 Unplug the AC power cord from the
wall outlet.
You may unplug the AC power cord
before the fan stops.
To move the projector just after turning it
off, be sure to wait until the fan stops
before unplugging the AC power cord.
Unplugging the AC power cord before the
fan stops may cause a malfunction.
To erase the confirmation message
The message disappears if you press any key
other than the
?/1 key on the main unit or 1
key on the Remote Commander, or if you do
not press any key for a while.
To turn off the power with the key
on the main unit without a
confirmation message being
displayed
Hold the ?/1 key on the main unit pressed
for a few seconds.
Turning Off the Power
Note