Filter
Top Products
29
The Installation Menu
Adjustments and Settings Using a Menu
The Installation Menu
The Installation menu is used for installing the projector.
VPL-FH35/FH30/VPL-FX37/FX35/FX30
*1: Do not use the projector at an altitude of 2,700 m or higher.
*2: Available for VPL-FH35/FH30 only
*3: Depending on the position adjusted with the lens shift feature, the aspect ratio of the image may
change from the original or projected image may be distorted with Keystone adjustment.
*4: Since the Keystone adjustment is an electronic correction, the image may be deteriorated.
*5: Depending on the adjustment value of “Panel Alignment,” the color and aspect ratio may be
changed.
*6: The brightness and color of the projected image may not match completely, even after you adjust
“Brightness” and “Color.”
Setting items Description
Image Flip HV/H/V/Off: Flips the projected image horizontally and/or vertically
according to the installation method.
Installation Attitude Right Side Up/Upside Down: Change the cooling setting to suit to the
installation attitude. Continuing to use the wrong setting may affect
component reliability.
High Altitude
Mode
*1
On/Off: Set to “On” when using the projector at an altitude of 1,500 m or
higher. Continuing to use the wrong setting may affect component
reliability.
Screen Aspect
*2
16:10/16:9/4:3: For switching the display area to suit to the screen.
V Keystone
*3 *4
The higher the setting, narrower the top of the projected image. The lower
the setting, the narrower the bottom.
Panel Alignment
*2 *5
This feature allows you to adjust the gaps in the color of characters or the
picture.
When set to “On,” “Adjust Color” and “Pattern Color” can be assigned and
adjusted.
Adjust Item: Selects how to make adjustments from below.
Shift: Shifts the whole picture and makes adjustments.
Zone: Selects the desired range and makes adjustments.
Adjust Color: Assigns the desired color to adjust the gaps in color. Select
“R” (Red) or “B” (Blue) to make adjustments based on “G” (Green).
Pattern Color: Select “R/G” (Red and Green) or “R/G/B” (White, all
colors) when “Adjust Color” is “R” (Red). Select “B/G” (Blue and Green)
or “R/G/B” (White, all colors) when the “Adjust Color” is “B” (Blue).
Adjust: The shift adjustment and zone adjustment of the color selected in
“Adjust Color” can be made with V/v/B/b buttons.
Reset: The panel alignment settings are initialized to their factory preset
values.
Color Matching
*2 *6
Adjust/Reset: For correcting the brightness and color of the whole
projected image manually from the signal level in six steps.
Notes