Filter
Top Products
40
GB
Troubleshooting (continued)
Error messages
Error message
“PRE SET”
“BACK-D”
“NO ERASE”
“NO DATA”
“SET DATE”
“ID FULL”
“FULL”
“ACCESS”
Cause/Remedy
•You set the alarm to play back a message or set
the timer to start recording at a date and time
previously set on another message. Change the
alarm or timer recording setting.
•You set the alarm or time recording when the
time is already past. Check it and set the
appropriate date and time.
•You cannot erase an index to combine
messages of different modes.
•The selected folder does not have any
messages. You cannot set the alarm, etc.
because of this.
•If you do not set date and time, you cannot
make alarm or time recording setting. To set
date and time, see page 8.
•When there are already 99 messages in the
selected folder or the remaining memory of the
IC recorder is short, you cannot add an index.
Erase some messages before adding an index.
•The remaining memory of the IC recorder is
too short. Erase some messages before
recording.
•You inserted the batteries. Wait until the
message disappears before starting operation.