Filter
Top Products
Hardware Installation
SY-7ISA+
28
2. Reset
Plug the Reset push-button cable into the 2-pin Reset header on the
Motherboard. Pushing the Reset button on the front panel will cause the
system to restart the boot-up sequence.
3. Speaker
Attach the 4-pin PC speaker cable from the case to the Speaker header on
the Motherboard.
4. STR LED
The STR LED is connected to the Voltage that feeds the DIMM sockets.
Therefore the following table applies:
Suspend to RAM Normal Operation Power Off
STR LED Blinking OFF ON
Reset Pin Assignment
Power Good GND
1
Speaker Pin Assignment
+
_
+5V
Speaker out
NC NC
STR LED Pin Assignment
+
_
LED Anode
LED Cathode