Filter
Top Products
Hardware Installation
SY-7ISA+
44
2-3.5 Voice Doctor
If the system does not boot-up properly, the Voice Doctor will
inform the user by voice through internal/external speaker at
what point in boot-up sequence the problem arises.
Below are the possible errors the user may encounter:
1. The Processor might be damage or not installed properly
2. The memory module might be damage or not installed
properly
3. No Keyboard connected
4. VGA card might be damage or not inserted properly
5. Defective HD-Driver (IDE)
6. Floppy might have an error
Voice Doctor supports two language, refer the table below on the
language you prefer.
Voice Doctor’s language English Language Chinese Language
JP33 Setting
Short pin 1-2 Short pin 2-3
2-3.6 CMOS Clear (JP5)
In some cases the CMOS memory may contain wrong data, follow the
steps below to the clear CMOS memory.
1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper
JP5. This jumper can be easily identified by its white colored cap.
2. Then put the jumper back to 1-2 to allow writing of new data into the
CMOS memory.
CMOS
Clearing
Clear CMOS Data Retain CMOS Data
JP5 Setting
Short pin 2-3 for
at least 5 seconds
to clear the CMOS
Short pin 1-2
to retain new
settings
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
123
123
123
123