Filter
Top Products
Drivers Installation SY-5EMA
65
Step 2. Installation procedure for Windows 95/98
The following describes the best way of installing Windows 95 or Windows 98 on your
5EMA mainboard:
Ø The following BIOS default settings should not be changed:
1. The ‘USB Controller’ item under ‘Chipset features’ is set to enabled.
2. The ‘USB Assigned IRQ’ item under ‘PnP/PCI Configuration is set to enabled.
You MUST have these two items enabled for Windows 95/98 to run properly on your
system.
Ø Install Windows 95/98
Ø After installation of windows, you will need to install the ETEQ drivers. Follow the
instruction below.
Click the Install Drivers button to display the list of drivers that can be installed on your
mainboard. The start-up program displays the drivers available for the 5EMA and the
Windows version you use. For Windows 95 four drivers will be listed (see ‘Driver Installation
Menu’ below), for Windows 98 three drivers will be listed (the ACPI drivers will be left out).
We recommend you to install all drivers, and to do so in the right sequence (top to bottom).
If you want to see all the drivers available on the SOYO –CD, click the Display all drivers
on the SOYO CD button. Do NOT install drivers that are not suitable for you board,
otherwise your system may crash.
(Driver Installation Menu)