SOYO SY-6KE Computer Hardware User Manual


 
SY-6KE
Quick Start Guide
11
Hardware
Installation
3
3
Quick BIOS Setup
This mainboard does not use any hardware jumpers to set the CPU frequency. Instead,
CPU settings are software configurable with the BIOS
[CHIPSET FEATURES SETUP].
After the hardware installation is complete, turn the power switch on, then press the
<DEL>
key
during the system diagnostic checks to enter the Award BIOS Setup program. The CMOS
SETUP UTILITY will display on screen. Then, follow these steps to configure the CPU settings.
Step 1. Select [LOAD SETUP DEFAULT]
Select the LOAD SETUP DEFAULT menu and type Y at the prompt to load the BIOS
optimal setup.
Step 2. Select [STANDARD CMOS SETUP]
Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to Auto.
Step 3. Select [CHIPSET FEATURES SETUP]
Move the cursor to the
[CPU Speed]
field to set the CPU frequency.
Available [CPU Speed] settings on your SY-6KE Mainboard are detailed in the following
table. If you set this field to [Manual], you are then required to fill in the next two consecutive
fields: (1) the [CPU Host Clock], and (2) the [CPU Ratio].
CPU Speed
233MHz (66 x 3.5)
266MHz (66 x 4.0)
300MHz (66 x 4.5)
333MHz (66 x 5.0)
366MHz (66 x 5.5)
Select the working frequency of your
Pentium
®
II processor among these
preset values.
Note: Mark the checkbox that
corresponds to the working frequency of
your Pentium
®
II processor in case the
CMOS configuration should be lost.
Step 4. Select [SAVE & EXIT SETUP]
Press
<Enter>
to save the new configuration to the CMOS memory, and continue the boot
sequence.