SY-6KE
Quick Start Guide
9
Hardware
Installation
Step 3. Configure Memory
Your board comes with three DIMM sockets, providing support for up to 384MB of main
memory using DIMM modules from 8MB to 128MB with no restriction on memory
configuration. Therefore, you can install memory modules in any combination.
For 66MHz front side bus CPUs use 12ns or faster memory.
Memory Configuration
DIMM BanksMEMORY
CONFIGURATION
DIMM 1 DIMM 2 DIMM 3
RAM Type EDO/SDRAM EDO/SDRAM EDO/SDRAM
RAM Module Size
(MB)
8/16/32/64/128 8/16/32/64/128 8/16/32/64/128
Notice 1: Only install 3.3V EDO DIMM modules on this mainboard; other voltages are
not supported by the SY-6KE mainboard.
Notice 2: Do not install EDO types of DIMM when you already use SDRAM.
Step 4. Set the CPU Frequency
You do not need to set any jumper for the CPU frequency. Instead, CPU setting are changed
through the BIOS [CHIPSET FEATURES SETUP]. Please refer to Chapter 3 - Quick BIOS
Setup for details on how to set the Pentium
®
II processor frequency.
Step 5. Enable/Disable PS/2 Keyboard Wake-Up (JP10)
You can choose to enable the Wake-Up by PS/2 Keyboard or Mouse function by shorting
pin 1-2 on jumper JP10, otherwise, short pin 2-3 to disable this function.
Support Wake-Up
by Keyboard
Enable Disable* (*Default)
JP10 Setting
Enable Wake-up
by Keyboard or
Mouse function
(short pin 1-2)
Disable Wake-up
by Keyboard or
Mouse function
(short pin 2-3)
3
2
1
3
2
1