Filter
Top Products
Appendix F 177
Ethernet Configuration
The Ethernet Configuration menu allows you to configure the ethernet
port. To launch the Ethernet Configuration menu, select
3.
To configure the ethernet port, use the following commands:
[1] DHCP: Either enabled or disabled. Make sure to provide a hostname
when DHCP is enabled; it is necessary to provide system identification to
the DHCP host. If DHCP is disabled, you must provide a static IP
address.
[2] Hostname: The name for the IP interface. This is used by DHCP and
DNS for name resolution. The hostname should be less than 12
characters to support DHCP and DNS naming conventions.
[3] IP address: Standard IP address. This field is not available while in DHCP
mode.
[4] IP subnet mask: IP network mask (standard IP parameter).
[5] IP gateway: Gateway address (standard IP parameter).
Figure 11-15 The Ethernet Configuration menu.