Support User Manuals

Spectra Logic T680 Computer Drive User Manual

Open as PDF

of 22

Replace or Install a Drive

10

Drive Installation or Replacement Instructions 91010010

Drive Installation Preparation

Thissectiondescribeshowtopreparetoaddanewdrivetothelibrary.If

youarereplacingadrive,followthestepsinDriveReplacement

Preparationonpage 8.

1. Logintothelibrarywithsuperuseroradministratorprivileges.

2. Fromthetoolbarmenu,selectConfiguration > Drives.TheDrives

screenappears.

3. SelectAddinthelocationwhereyouwanttoaddadrive.

AFeedbackRequiredscreenpromptsyoutoconfirmthatyouwantto

addthedrive.

4. SelectOK.

Accessing the Drives

Thissectiondescribeshowtoaccessthetapedrives.

Spectra T200 or T380 Removetheprotectivecoverinordertoinstallor

replacedrives.

1. Fromtherearofthelibrary,locatethetwoknurledscrewssecuringthe

bottomofthecovertoeithersideofthechassis(Figure 4).

Figure 3 The Drives screen.

Important

Do not respond to the prompt in the Feedback Required screen or perform any

other operations from the user interface (either locally or remotely) until you

complete the replacement procedure. Responding before you replace the drive will

power on and configure the drive you just powered down.

previous next