Filter
Top Products
SM06 Rev. 4.10 Tac/Com Control Head Manual
3.5.1 Channel Editing
EDIT Switch
When the EDIT switch is in the CH position, the ID, RX, and TX information may be
edited. The position or character to be edited will flash or blink on and off. When
channel editing of data is in progress, operation of the radios is suspended, and the
dual function edit switches work in the following way:
3.5.1.1 SELECT Switch
SELECT
Switch
This switch is used to step the data entry up or down (+/-) on the currently marked radio.
The character that will be selected flashes. This flashing character is referred to as the
editing cursor, since it shows what is about to change. The intelligent editor within the
control head only permits a valid choice for every position for data entry. This is to aid
operators in reducing entry mistakes, particularly when busy with other flight
procedures.
The selection choices are strung together in a circle, and choices move through this
circle with the SELECT switch as shown below in the diagram:
Jan 4, 2006 Page 3-11
ENG-FORM: 806-0106.DOT
CONFIDENTIAL AND PROPRIETARY TO NORTHERN AIRBORNE TECHNOLOGY LTD.