Filter
Top Products
SpectraLink Corporation Installation, Configuration, and Administration
NetLink SVP Server (within IP environments)
PN: 72-0178-01-F.doc Page 19
To change the IP address of the master SVP Server, change it in this menu
and reboot the system. Then you may change alias IP addresses in each of
the other SVP Servers without error.
The following options must be configured:
IP Address
Enter the IP address of the NetLink SVP Server, defined by your network
administrator. Enter the complete address including digits and periods. DHCP
may be entered.
A master SVP Server must have a static IP address.
The NetLink SVP Server will automatically lock for maintenance if the IP
address is changed. When this Maintenance Lock occurs, the NetLink SVP
Server must be reset upon exit. All active calls are terminated during a reset.
Hostname
(Optional) change the default host name, if desired. This is the name of the
NetLink SVP Server to which you are connected, for identification purposes
only. You cannot enter spaces in this field.
Subnet Mask
The network administrator must define the subnet mask.
Default Gateway
The IP address of a router on the local subnet.
SVP-II TFTP Download Master
This entry indicates the source of software updates for the NetLink SVP Server.
See section 5, the
Software Maintenance
section, for more information.Valid
source location entries are:
•
NONE: disables.
• IP Address: The IP address of a network TFTP server that will be used to
transfer software updates to the NetLink SVP Server.
DNS server and DNS domain
These settings are used to configure Domain Name services. Consult your
system administrator for the correct settings. These can also be set to DHCP. This
will cause the DHCP client in the NetLink SVP Server to attempt to
automatically get the correct setting from the DHCP server. The DHCP setting
is only valid when the IP address is also acquired using DHCP.
WINS servers
These setting are used for Windows Name Services. Consult your system
administrator for the correct settings. These can also be set to DHCP. This will
cause the DHCP client in the NetLink SVP Server to attempt to automatically
get the correct setting from the DHCP server. The DHCP setting is only valid
when the IP address is also acquired using DHCP.