Filter
Top Products
Section 2A. Installing the Software 9
Installing the Software
Installing the Software and Drivers
1. Insert the installation CD for Sprint SmartView, into your PC's CD-
ROM or DVD-ROM drive. The installer should run automatically. If
the setup program does not start, go to Finder and open the
contents of the CD drive. Click to open Sprint SmartView
Installer.mpkg.
2. Follow the on-screen instructions, using the Continue and Go Back
buttons to navigate through the installation wizard, noting the
following:
Ⅲ In order to continue with the installation, you must accept the
terms of the License Agreement.
Ⅲ Click Install to load the software. You may be prompted to restart
your computer to after the installation completes, if so, click
Continue Installation.
Ⅲ Click Restart to complete the installation once the Finish Up screen
appears.
Note
As part of the installation process you will be prompted to restart your
computer; save any open documents.
Important
Do not insert your Express Card Modem until you have installed
Sprint SmartView onto your computer or until instructed to do so by
Sprint SmartView.
Note
The Sprint SmartView software can also be downloaded from
www.sprint.com/downloads.