SMSC SCH5027E Computer Hardware User Manual


 
SMSC SCH5027E PRODUCT PREVIEW Revision 0.2 (02-11-09)
Data Brief
PRODUCT FEATURES
SCH5027E
Super I/O with
Temperature Sensing,
Quiet Auto Fan and
Glue Logic with PECI
General Features
3.3 Volt Operation (SIO Block is 5 Volt Tolerant)
—LPC Interface
Programmable Wake-up Event Interface
PC99, PC2001 Compliant
ACPI 2.0 Compliant
Multiplexed Command, Address and Data Bus
Serial IRQ Interface Compatible with Serialized IRQ
Support for PCI Systems
PME Interface
ISA Plug-and-Play Compatible Register Set
25 General Purpose Input/Output Pins
System Management Interrupt
PECI Interface
Supports PECI REQUEST# and PECI AVAILABLE
signalling
AC Power Failure Recovery
Watchdog Timer
2.88MB Super I/O Floppy Disk Controller
Licensed CMOS 765B Floppy Disk Controller
Software and Register Compatible with SMSC's
Proprietary 82077AA Compatible Core
Supports One Floppy Drive
Configurable Open Drain/Push-Pull Output Drivers
Supports Vertical Recording Format
16-Byte Data FIFO
100% IBM® Compatibility
Detects All Overrun and Underrun Conditions
Sophisticated Power Control Circuitry (PCC) Including
Multiple Powerdown Modes for Reduced Power
Consumption
DMA Enable Logic
Data Rate and Drive Control Registers
480 Address, Up to Eight IRQ and Three DMA Options
Support 3 Mode FDD
Enhanced Digital Data Separator
2 Mbps, 1 Mbps, 500 Kbps, 300 Kbps, 250 Kbps Data
Rates
Programmable Precompensation Modes
Serial Ports
Two Full Function Serial Ports
High Speed NS16C550A Compatible UARTs with
Send/Receive 16-Byte FIFOs
Supports 230k and 460k Baud
Programmable Baud Rate Generator
Modem Control Circuitry
480 Address and 15 IRQ Options
Infrared Port
Multiprotocol Infrared Interface
IrDA 1.0 Compliant
SHARP ASK IR
480 Addresses, Up to 15 IRQ
Multi-Mode™ Parallel Port with ChiProtect™
Standard Mode IBM PC/XT®, PC/AT®, and PS/2™
Compatible Bi-directional Parallel Port
Enhanced Parallel Port (EPP) Compatible - EPP 1.7
and EPP 1.9 (IEEE 1284 Compliant)
IEEE 1284 Compliant Enhanced Capabilities Port
(ECP)
ChiProtect Circuitry for Protection
960 Address, Up to 15 IRQ and Three DMA Options
Keyboard Controller
8042 Software Compatible
8 Bit Microcomputer
2k Bytes of Program ROM
256 Bytes of Data RAM
Four Open Drain Outputs Dedicated for
Keyboard/Mouse Interface
Asynchronous Access to Two Data Registers and One
Status Register
Supports Interrupt and Polling Access
8 Bit Counter Timer
Port 92 Support
Fast Gate A20 and KRESET Outputs
Motherboard GLUE Logic
IDE Reset Output
(4) Buffered PCI Reset Outputs with software controlled
reset capability - default transparent
Front Panel Reset Debouncing and Power Good Signal
Generation
Power Supply Turn On Circuitry with Support for power
button on PS/2 Keyboard
Resume Reset Signal Generation
SMBus Isolation Circuitry (2 sets external and 1 set
internal for Hardware Monitoring Block)
SMBus 2.0 compliant interface for Hardware Monitoring
LED Control (2)
Fan Control
5 PWM (Pulse width Modulation) Outputs
Low frequency and high frequency PWM support
6 Fan Tachometer Inputs
Programmable automatic fan control based on
temperature
Interrupt Pin for out-of-limit Fantach Events
Fantach events generate PME’s