disabled (ON), the computer must send both a line feed code and a carriage
return code at the end of each line. Most applications do this automatically.
32 Using the EDS Mode
Note the following check points when trying to figure out which setting to use here:
3 If you find that your output is double-spaced when it should not be, turn
this switch ON (Disabled).
3 If you find that lines are printing over each other, turn this switch OFF
(Enabled).
Switch 6: Quiet mode
When the Quiet Mode is enabled (OFF), the printer prints with less noise than
normal printing. Though the Quiet Mode prints more quietly, it also takes
considerably longer than normal printing.
Switch 7: Not Used
BANK B
Switches 1,2: Print mode
Turn these switches on or off to select the print mode you want to use.
ON, ON :LQ mode
ON, OFF :HS-LQ mode
OFF,ON :Draft mode
OFF,OFF :HS-Draft mode
Switches 3, 4, 5: Print Pitch
Turn these switches on or off to form the pattern that matches the print pitch
setting you want to make.
ON, ON, ON :10cpi OFF,ON, ON :20cpi
ON, ON, OFF :12cpi OFF,ON, OFF :Proportional
ON, OFF,ON :15cpi OFF,OFF,ON :10cpi
ON, OFF,OFF :17cpi OFF,OFF,OFF :10cpi
Switch 6: LQ Font Selection
Selects Roman (ON) or Sanserif (OFF) font to use for LQ printing.