Star Micronics SP298MD Printer User Manual


 
11
ENGLISH
Loop the fastener around the cable and lock it. Use scissors to cut off any
excess.
Plug one end of the modular cable into the modular jack of the peripheral.
Remove the modular jack cover from the back of the printer and plug the
other end of the modular cable into the jack of the printer.
Inserting the paper into the printer
Use only the specified type of paper for this printer. Do not use inappropriate
types of paper, or it could cause malfunction or damage of the printer.
The following procedure describes how to print on paper. Before trying to print,
be sure to install a ribbon cassette into the printer using the procedure under
Installing the ribbon cassette on page 4.
Make sure that the printer is plugged in and turned on.
Check that the
RELEASE
indicator on the control panel is lit. If the
indicator is not lit, press the
RELEASE
button until the indicator lights up.
Important!
Insertion and removal of paper should be done only when the printer is
released condition (the paper is not held by paper feed roller).
Pull and cut