Filter
Top Products
– 13 –
ENGLISH
7. Command Summary
This printer supports two different command modes: the Star mode and the ESC/
POS mode.
This chapter provides you with all of the commands supported by this printer.
Important!
Access the following URL for the latest version of this manual and for
updates on supported commands: http://www.star-micronics.co.jp/
service/sp_sup_e.htm
7-1. Star Mode
Commands to Select Characters
Control codes
Hexadecimal
Function
codes
<ESC> “R” n 1B 52 n Select international character set
<ESC> <GS> t n 1B 1D 74 n Select character table
<ESC> “/” “1” 1B 2F 31
Select slash zero
<ESC> “/” <1> 1B 2F 01
<ESC> “/” “0” 1B 2F 30
Select normal zero
<ESC> “/” <0> 1B 2F 00
<ESC> “b” n1 n2 n3 n4 1B 62 n1 n2 n3 n4 Select bar code printing
d1 ... <RS> d1 ... 1E
<ESC> “M” 1B 4D Select 12-dot pitch printing
<ESC> “p” 1B 70 Select 14-dot pitch printing
<ESC> “P” 1B 50 Select 15-dot pitch printing
<ESC> “:” 1B 3A Select 16-dot pitch printing
<ESC> <SP> n 1B 20 n Set character spacing
<SO> 0E Sets the printing magnified double in
character width.
<DC4> 14 Resets the printing magnified in
character width.
<ESC> “W” n 1B 57 n
Sets the magnification rate in character width.
<ESC> <SO> 1B 0E Sets the printing magnified double in
character height.
<ESC> <DC4> 1B 14 Resets the printing magnified in character
height.
<ESC> “h” n 1B 68 n
Sets the magnification rate in character height
.
<ESC> “
–
” “1” 1B 2D 31
Select underlining
<ESC> “
–
” <1> 1B 2D 01