Instruction Manual
7
2. Once the copy has completed, the green LED will stop blinking. The destination
Flash drive can be removed and a new Flash drive inserted, then the copy will
automatically start again. The LCD display will show the accumulated quantity of the
successful/failed duplications and the drive that is still copying.
NOTE:
a) When the copy is in progress, the green LED will ash for each Flash drive that is
connected. When the copy has nished, the green LED will stop ashing and remain
illuminated. If an error occurs, the red LED will illuminate.
b) Do NOT remove the Flash drive while the system is copying (green LED is ashing).
c) Once the copy process has completed (green LED is solid), you can then take out
that Flash drive and insert a new one.
d) During an Asynchronous copy, you can press the up and down arrows to check each
Flash drive’s copy status and progress. This works both during a copy (green LED
ashing) and when there is an error (red LED solid).
2. Compare
Check the Flash drive after a copy has completed to ensure the copy has completed
successfully.
3. Copy + Compare
Automatically compares the Flash drive once the copy has completed.