Filter
Top Products
Instruction Manual
6
3. When the copy has completed, the LCD display will show the total time it took to
copy, the number of passes, and if there were any failures.
NOTE:
a) When the copy is in progress, the green LED will ash for each Flash drive that is
connected. When the copy has nished, the green LED will stop ashing and remain
illuminated. If an error occurs, the red LED will illuminate.
b) Do NOT remove the Flash drives while the system is copying (green LED is ashing).
You can cancel duplication by pressing ESC.
c) It is recommended that the source and destination are the same size. Copying to or
from a larger Flash drive may cause an error and the copy will fail.
d) If copying a Flash drive with NTFS or Linux le formats, the destination capacity
MUST BE equal or larger than the source’s capacity.
1.2 Asynchronous Copy
NOTE: This mode is enabled by default. The source’s content size must be smaller
than the system’s buer memory, otherwise the system will automatically duplicate in
Synchronous mode.
To enable Asynchronous mode, go to function “7.6 Asynchronous”, and select “Enable”.
Operating Process
1. Plug in the source Flash drive, and press OK. The system will start to read the
source’s content into the system’s buer. Once completed, it will immediately start
to copy once a destination Flash drive has been plugged in.